Grundig UMS 4100 Portable Stereo System User Manual


 
32
TIMER MODE
__________________________________________________________________
Your stereo system has two timer modes:
– The switch-on timer, which switches the stereo system on and off at a pre-set
time.
– The sleep timer, which switches off the stereo system at a pre-set time.
Switch-on timer
Setting the switch-on timer
Note:
The clock on the device must have been set. If, when setting the time, no but-
ton is pushed for a period of longer than 10 seconds, the system will end the
process automatically. You then have to start again at the beginning. During
setting, the display can be illuminated for approximately 8 seconds by pres-
sing any of the buttons.
1 With the device switched off, press and hold down »TIMER«.
– Display: »
w
« and »ON«, the hour display flashes.
2 Set the hours for switching on using »
TUNING UP/DOWN
« on the device.
3 Press »TIMER«.
– Display: »
w
« and »ON«, the minute display flashes.
4 Set the minutes for switching on using »
TUNING UP/DOWN
« on the
device.
5 Press »TIMER«.
– Display: »
w
« and »OFF«, the hour display flashes.
6 To enter the switch-off time, repeat steps 2 to 4.
7 Press »TIMER«.
– Display: »
w
« »TUNER« or »CD«.
8 Select the CD or tuner input source using »
TUNING UP/DOWN
« on the
device.
Note:
If you select CD, make sure that a CD has been inserted.
0n 1200
:
w
0n 1 8 00
:
w
off 12 00
:
w