Filter
Top Products
14
SETTINGS
____________________________________________________________________________
Setting the clock
The following settings can only be carried out in stand-by mode.
1 To set the 12-hour format, briefly press » TIME«.
– Display: »12HR« briefly, then the current time e.g. »PM 1:25« (»AM« for
the morning, »PM« for the afternoon/evening).
2 To set the 24-hour format, press » TIME« again.
– Display: »24HR« briefly, then the current time e.g. »13:25«.
3 To set the time, press and hold down » TIME«.
– Display: The hours flash.
4 Set the hours using »
TUNING UP/DOWN
« on the device.
5 Confirm the input with » TIME«.
– Display: The minutes flash.
6 Set minutes with »
TUNING UP/DOWN
« on the device.
Note:
You must reset the time after a power failure or when the mains plug is pul-
led out.
7 Confirm the input with » TIME«.
– Display: e.g. »CT ON«.
– The RDS time synchronization is activated.
Note:
If the RDS time information is received via an RDS station, the time sets itself
automatically.
When receiving and RDS station, the time is continuously updated later pro-
vided that an appropriate time signal is transmitted and the function is swit-
ched on.
CT ON
1014
:
1214
:
PM
125
: