Filter
Top Products
AE/LZB 119 1902 R1A
28
DISASSEMBLY PROCEDURE
To disassemble the LPE-200 radio:
Figure 9
1. Remove the battery pack by pushing the battery release
button and sliding the battery pack straight back until it
stops, then lift the battery pack out. When replacing the
battery pack align the ribs on the sides of the battery
pack with the slots in the sides of the radio. Push down
and slide the battery pack into place.
If the radio is equipped with a belt clip it may be
necessary to lift up on the clip when replacing battery
pack
Figure 9 - Removing the Battery Pack
Figure 10
2. Remove the control knobs and stop washer.
3. Using a T7x50 TORX
driver, remove the screws at
(
A
).
4. Insert a small flat head screwdriver between the plastic
front cover and the metal frame at location (
B
). Gently
pry each side of the plastic front cover out while prying
the metal frame up to release the plastic snaps securing
the metal frame to the front cover.
A
B
Figure 10 - Removing Front Cover
Figure 11
5. Once the plastic snaps have been released, separate the
metal frame from the front cover. First lift up on the
bottom of the metal frame and then slide and lift the
metal frame down and away from the front cover.
Figure 11 - Metal Frame Separated From The Front
Cover
Figure 12
6. Carefully unplug the flex circuit at the bottom of the
radio (
C
).
7. Remove gasket.
Note:
when replacing the gasket watch
for bulging sections.
8. Using a flat head screw driver, remove the PA nuts at
(
D
)
9. Pry clips loose from both sides of the metal frame at
(
E
).
C
D
E
Figure 12 - Remove Flex Circuit, PA Nuts And Side
Clips
NOTE