Filter
Top Products
AE/LZB 119 1902 R1A
26
Error Name Message Code Description
PIFEAT_SNR_ERROR FEAT ERR 550 Feature encryption - Cannot read radio ROM serial
number.
PIFEAT_READ_ERROR FEAT ERR 551 Personality feature encryption read failure or data not
available.
PIFEAT_CRC_ERROR FEAT ERR 552 decryption failure. Personality feature encryption CRC
failure.
RI_DSPDOWN_NOATTEMPT DSP ERR 850 DSP not found.
RI_DSPDOWN_NOTFOUND DSP ERR 851 DSP file not found.
RI_DSPDOWN_CRCFAIL DSP ERR 852 DSP file is corrupted.
RI_DSPDOWN_ENCERR DSP ERR 853 Radio feature encryption does not match DSP file.
RI_DSPDOWN_PMFAIL DSP ERR 854 DSP file is corrupted or hardware failure. Reprogram
radio or power cycle the radio.
RI_DSPDOWN_DMFAIL DSP ERR 855 DSP file is corrupted or hardware failure. Reprogram
radio or power cycle the radio.
RI_DSPDOWN_BIOSERR DSP ERR 856 Hardware failure.
AEGIS_KEYLOAD_NOBANKS NO KBANK 860 Attempt to keyload radio w/o bank storage.
AEGIS_PVT_NONE NO PVT 870 Attempt to keyload radio w/o private DSP file.
Radio Programming Errors
Programming errors are divided into three categories.
Protocol Errors Produced By The Low Level Communication Routines
Message Code Description
Successful 0 Command was performed successfully.
Protocol- Canceled by receiver 5 x328 protocol received a cancel, The radio detected a cancel
command.
Protocol- Canceled by sender 6 x328 protocol transmitted cancel. The radio is canceling the read
command.
Protocol- Terminate transmission 7 x328 protocol received an end of transmission.
Protocol- Transmit error 8 x328 protocol could not transmit. Reliable communication can not be
established. It could be radio or PC hardware problems
(programming cable, interface box or radio hardware).
Protocol- Protocol initialization error 9 x328 protocol not initialized or failed to initialize.
Radio Errors That Are Returned From The Bootloader Software
Message Code Description
Radio- Programmed successfully 10 Radio responded with a success. Radio acknowledged successful
programming.
Radio- Comport configuration failed 11 Radio could not configure its comport (hardware failure).
Radio- Flash erase failed 12 Radio failed to erase the flash memory. The radio flash memory
part is unusable or it can not detect the 12 volts power, Check the
programming box and cables.
Radio- Flash write failed 13 Radio failed in writing to the flash memory. Retry the programming
process (hardware failure).
Radio- Flash code CRC did not match 14 Flash code not programmed correctly, CRC did not match, the
operating software will not execute. Re-program the radio.