Filter
Top Products
AE/LZB 119 1902 R1A
23
Non-Fatal Errors
Non-fatal errors are displayed for a short period (about two seconds) then normal radio operation will resume.
Non-Fatal Errors
Error message Description
UNKNOWN Undocumented error.
FEAT ERR Feature encryption error.
DSP ERR DSP error.
NO KBANK Attempt to keyload w/o bank storage.
NO PVT Attempt to keyload w/o private DSP file loaded.
Special Error Codes
When the synthesizer becomes unlocked on any frequency (RX or TX), the radio will display a message and sound an
alert tone. The message will be displayed for approximately 2 seconds and the alert tone will continuously beep on and off.
During this time, the radio is trying to reload the synthesizer to get a lock condition. If the lock condition is achieved, the
unlock indications will cease. If the lock condition can not be achieved, the user will not be able to RX or TX on that
frequency. The message displayed on the radio is shown below:
ERROR CODES - SPECIFIC
Hardware Fatal System Errors
Hardware fatal errors will automatically reset the radio. When the radio reset does not correct the problem, the radio
must be serviced.
Error Name Message Code Description
FATAL_SYS_TRAP HARDWARE 0 Fatal system error trap number.
FATAL_NMI_ERROR HARDWARE 1 NMI occurred outside of sleep.
FATAL_RAM_ERROR HARDWARE 2 8k RAM test error.
FATAL_FLSH_CHKSUM HARDWARE 4 Flash checksum test error.
FATAL_TG_LOAD HARDWARE 10 TG driver failed initialization.
FATAL_DSP_LOAD HARDWARE 11 DSP driver failed initialization.
FATAL_ABBIE_LOAD HARDWARE 12 ABBIE driver failed initialization.
FATAL_EE_LOAD HARDWARE 13 EEPROM driver failed initialization.
FATAL_INTOUT_LOAD HARDWARE 15 Standard input/output driver failed initialization.
FATAL_INTIN_LOAD HARDWARE 16 Standard input driver failed initialization.
FATAL_RADIO_LOAD HARDWARE 17 RADIO driver failed initialization.
FATAL_MODEM_LOAD HARDWARE 18 MODEM driver failed initialization.
FATAL_EXTIO_LOAD HARDWARE 19 External I/O driver failed initialization.
FATAL_SCI_LOAD HARDWARE 20 Serial communication interface driver failed
initialization.
FATAL_I2C_NOSI HARDWARE 22 I2C failed to return SI status.