Filter
Top Products
English
280-8180-00
64 DXZ958RMC
9. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
ERROR 2
ERROR 3
ERROR 6
ERROR 7
ERROR 8
ERROR 9
ERROR 2
ERROR 3
ERROR 6
ERROR 2
ERROR 3
ERROR 6
ERROR P
ERROR R
AMP GUARD
Error Display Measure
A DISC is caught inside the CD deck and is
not ejected.
A DISC cannot be played due to scratches,
etc.
A DISC is loaded upside-down inside the
CD deck and does not play.
The format of the flash memory is damaged.
There is a failure with the flash memory.
An error during recording, scratch on the
disc, or error due to sound skips
A DISC inside the CD changer is not
loaded.
A DISC inside the CD changer cannot be
played due to scratches, etc.
A DISC inside the CD changer cannot be
played because it is loaded upside-down.
A DISC inside the DVD changer cannot be
played.
A DISC cannot be played due to scratches,
etc.
A DISC inside the DVD changer cannot be
played because it is loaded upside-down.
Parental level error
Region code error
The speaker protection circuit is operating.
During this operation, if any volume
operation is performed, the display shows
“AMP GUARD”.
“AMP GUARD” sometimes functions when
special test signals are used.
This is a failure of CD deck’s mechanism and
consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
Execute ALL ERASE on the flash memory,
and the problem is solved.
Turn POWER/ACC off and then turn it on
again, and the problem is solved.
Tu rn POWER/ACC off and then turn it on
again, or eject the CD. The problem is solved.
This is a failure of CD changer’s mechanism
and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
This is a failure of DVD mechanism and con-
sult your store of purchase.
Retry or replace with a non-scratched, non-
warped-disc.
Eject the disc then reload it properly
Set the correct Parental level.
Eject the disc and replace correct region
code disc.
1. Turn down sound volume. Function can
also be restored by turning the power off
and on again.
(Speaker volume is reduced automatically
when the speaker protection circuit oper-
ates).
2. If the sound is muted again, consult our
service department.
CD/MP3/WMA
DVD changer
CD changer
Cause
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
M.CATCHER
General
+DXZ958RMC_01-53-Eng.p65 05.1.20, 19:5364