Filter
Top Products
English
280-8180-00
50 DXZ958RMC
Common Operations
3. Touch on the left of the display to
select “TEL-SP”.
RTN
TEL-SP
RIGHT
ADJ
SETTING
4. Touch on the right of the display to
select “LEFT” or “RIGHT”.
LEFT:
Telephone calls can be heard on the front
left speaker connected to this unit.
RIGHT:
Telephone calls can be heard on the front
right speaker connected to this unit.
5. Press the [ADJ] button to return to the
original mode.
Cellular phone interrupt
setting
If you connect this unit and your cellular phone
with a unit (Optional, TEL-002), you can listen to
your telephone calls on your car speakers.
• The factory default setting is “OFF”.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [SETTING].
3. Touch
on the left of the display to
select “TEL-SWITCH”.
RTN
TEL-SWITCH
OFF
ADJ
SETTING
4. Touch on the right of the display.
Each time you touch, the setting changes in
the following order:
OFF ➜ ON ➜ MUTE ➜ OFF...
OFF:
This unit continues normal operation even
when the cellular phone is used.
Note:
• When connecting a hands-free kit, make sure
that the setting is ON to receive the telephone
audio through the system.
ON:
You can listen to your telephone calls from
the speakers connected to this unit.
∗ When listening to your calls on your car
speakers, you can adjust the volume by
turning the [ROTARY] knob.
MUTE:
The sound from this unit is muted during
telephone calls.
5. Press the [ADJ] button to return to the
original mode.
Setting the auto-volume
function
(CALIBRATE/A-VOL SENS)
You can automatically change the volume to
match your car's speed.
• The factory default setting is “LOW”.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [SETTING].
3. Touch on the left of the display to
select “CALIBRATE”.
RTN
CALIBRATE
[
START
]
ADJ
SETTING
4. Accelerate to a speed of 50 km.
5. When you reach 50 km, touch [START].
Calibration is executed.
After 2 seconds or longer, you will hear a
long beep, and “SUCCESSFUL” will appear
on the display.
If you hear a short beep, this indicates that
calibration failed. Repeat the procedure from
step 4.
6. Next, adjust the sensitivity. Touch
[SETTING].
7. Touch
on the left of the display to
select “A-VOL SENS”.
RTN
A-VOL SENS
LOW
ADJ
SETTING
8. Touch on the right of the display.
Each time you touch, the setting changes in
the following order:
OFF (no change in volume) ➜ LOW (change
in volume: small) ➜ MID-LOW ➜ MID ➜
MID-HIGH ➜ HIGH (change in volume:
large) ...
9. Press the [ADJ] button to return to the
original mode.
+DXZ958RMC_01-32-Eng.p65 05.1.21, 20:0650