Filter
Top Products
6. Configuration scheme
If a display or billboard is up and running, the user can start from step 3.
Connect the control PC with the DMP-100 processor, using a USB line on the USB-UART port, to update the
software and firmware used by the DMP-100 processor through the embedded Flash Load er software.
How to manipulate the embedded PC by connecting a displa y, keyboard and mouse?
1. Turn off the power of the DMP -100.
2. Disconnect the RS232 c able if one is c onnected to the RS232 interface.
3. Connect the DV I c able ( R9851210) between the DMP-100 processor and the LED-wall, using the LED Interface port.
Image 6-6
4. Connect a CRT or LCD display to the DMP-100 processor through the VGA port.
Image 6-7
5. Connect a keyboard and a mouse, using the KB/Mouse port or USB port.
Image 6-8
6. Turn on the C RT or LCD display.
7. Turn on the power of the DMP-100 and restart the operating system.
Note: The Led’s indicated with “PW R” and “MCU” will light up.
8. Wait until the operating system and RMS software are up and running.
9. Operate the DMP-100 by using the connected peripherals.
WARNING: Before turning off the DMP-100 processor, please first shut down all windows operation systems
and the embedded P C.
R59770263 DMP-100 15/09/2011 25