A SERVICE OF

logo

Open as PDF
next previous
28
Figure 12
• Lift the front cover into position onto the 4 corner studs (shown in Fig 12), with the use of the
lifting eye and appropriate lifting tackle, and hand tighten the four corner nuts (removed
earlier). Hand tighten the rest of the front cover bolts, remove the lifting equipment and
replace the lifting eye with the remaining front cover bolt. Work around the front cover
tightening all the bolts evenly (in a criss-cross sequence) to the required torque setting in
“Parts List”
Drain & Filler Plugs
• Line the thread of the breather tube with PTFE tape and tighten into position to give a leak
free seal