C-1
Cisco IE 3010 Switch Software Configuration Guide
OL-23145-01
APPENDIX
C
Unsupported Commands in
Cisco IOS Release 12.2(53)EZ
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the IE
3010 switch prompt but are not supported in this release, either because they
are not tested or because of switch hardware limitations. This is not a complete list. These unsupported
commands are listed by software feature and command mode:
• Access Control Lists, page C-2
• Archive Commands, page C-2
• Boot Loader Commands, page C-3
• Debug Commands, page C-3
• High Availability, page C-3
• IGMP Snooping Commands, page C-3
• Interface Commands, page C-4
• IP SLA, page C-4
• MAC Address Commands, page C-4
• Miscellaneous, page C-5
• NetFlow Commands, page C-6
• Network Address Translation (NAT) Commands, page C-6
• QoS, page C-6
• RADIUS, page C-6
• SNMP, page C-7
• SNMPv3, page C-7
• Spanning Tree, page C-7
• VLAN, page C-7
