39-10
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 39 Configuring IPv6 Host Functions and Unicast Routing
Understanding IPv6
Table 39-3 shows the supported EIGRP IPv6 router configuration commands.
For more complete syntax and usage information on these commands, see the Cisco IOS command
references.
EIPRP IPv6 supports the existing protocol-independent debug and show commands. Table 39-4 shows
the supported show, debug, and clear commands for EIGRP IPv6.
Table 39-3 EIGRP IPv6 Router-mode Commands
Command Purpose
ipv6 router eigrp as-number Specifies the EIGRP IPv6 routing process to be configured.
default-metric bandwidth delay reliability loading mtu Sets metrics for EIGRP IPv6.
distance internal-distance external-distance Allows the use of the best route to a node—either the internal or
external distance.
distribute-list prefix-list list-name Applies a prefix list to EIGRP IPv6 routing updates that are received
or sent on an interface.
log-neighbor-changes Enables the logging of changes in EIGRP IPv6 neighbor
adjacencies.
log-neighbor-warnings seconds Enables the logging of EIGRP neighbor warning messages.
maximum-paths number-paths Controls the maximum number of equal-cost routes that is
supported by a routing process for EIGRP IPv6.
metric weights tos k1 k2 k3 k4 k5 Tunes EIGRP metric calculations.
neighbor n:n:n:n::n interface-name Defines a neighboring router with which to exchange routing
information on a router that is running EIGRP.
passive-interface [interface-name | default] Disables sending routing updates on an interface.
redistribute source-protocol [process-id]
[include-connected] [target-protocol-options]
[source-protocol-options]
Redistributes IPv6 routes from one routing domain into another
routing domain.
router-id {ip-address | ipv6-address} Uses a fixed router ID.
shutdown Allows the user to shut down the EIGRP protocol. The no version
of this command starts EIGRP IPv6 without changing any
per-interface configuration.
stub [connected | receive-only | static | summary |
redstributed]
Configures a router as a stub that uses EIGRP.
timers active-time [time-limit | disabled] Adjusts routing wait time.
variance multiplier Controls load balancing in an internetwork based on EIGRP.
Table 39-4 EIGRP IPv6 Show and Debug Commands
Command Purpose
show ipv6 eigrp [as-number] interface Displays information about interfaces configured for EIGRP IPv6.
show ipv6 eigrp [as-number] neighbor Displays the neighbors discovered by EIGRP IPv6.
show ipv6 eigrp [as-number] traffic Displays the number of EIGRP IPv6 packets sent and received.
