38-55
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 38 Configuring IP Unicast Routing
Configuring BGP
Use the no router bgp autonomous-system global configuration command to remove a BGP autonomous
system. Use the no network network-number router configuration command to remove the network from
the BGP table. Use the no neighbor {ip-address | peer-group-name} remote-as number router
configuration command to remove a neighbor. Use the no neighbor {ip-address | peer-group-name}
remove-private-as router configuration command to include private autonomous-system numbers in
updates to a neighbor. Use the synchronization router configuration command to re-enable
synchronization.
These examples show how to configure BGP on the routers in Figure 38-6.
Router A:
Switch(config)# router bgp 100
Switch(config-router)# neighbor 129.213.1.1 remote-as 200
Router B:
Switch(config)# router bgp 200
Switch(config-router)# neighbor 129.213.1.2 remote-as 100
Switch(config-router)# neighbor 175.220.1.2 remote-as 200
Router C:
Switch(config)# router bgp 200
Switch(config-router)# neighbor 175.220.212.1 remote-as 200
Switch(config-router)# neighbor 192.208.10.1 remote-as 300
Router D:
Switch(config)# router bgp 300
Switch(config-router)# neighbor 192.208.10.2 remote-as 200
To verify that BGP peers are running, use the show ip bgp neighbors privileged EXEC command. This
is the output of this command on Router A:
Switch# show ip bgp neighbors
BGP neighbor is 129.213.1.1, remote AS 200, external link
BGP version 4, remote router ID 175.220.212.1
BGP state = established, table version = 3, up for 0:10:59
Last read 0:00:29, hold time is 180, keepalive interval is 60 seconds
Minimum time between advertisement runs is 30 seconds
Received 2828 messages, 0 notifications, 0 in queue
Step 12
show ip bgp network network-number
or
show ip bgp neighbor
Verify the configuration.
Verify that NSF awareness (graceful restart) is enabled on the
neighbor.
If NSF awareness is enabled on the switch and the neighbor,
this message appears:
Graceful Restart Capability: advertised and received
If NSF awareness is enabled on the switch, but not on the
neighbor, this message appears:
Graceful Restart Capability: advertised
Step 13
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
