Contents
xxix
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
CHAPTER
38 Configuring IP Unicast Routing 38-1
Supported IPv4 Features 38-2
Understanding IP Routing 38-3
Types of Routing 38-3
IP Routing and Switch Stacks 38-4
Steps for Configuring Routing 38-6
Configuring IP Addressing 38-6
Default Addressing Configuration 38-7
Assigning IP Addresses to Network Interfaces 38-8
Use of Subnet Zero 38-8
Classless Routing 38-9
Configuring Address Resolution Methods 38-10
Define a Static ARP Cache 38-11
Set ARP Encapsulation 38-12
Enable Proxy ARP 38-13
Routing Assistance When IP Routing is Disabled 38-13
Proxy ARP 38-13
Default Gateway 38-13
ICMP Router Discovery Protocol (IRDP) 38-14
Configuring Broadcast Packet Handling 38-15
Enabling Directed Broadcast-to-Physical Broadcast Translation 38-16
Forwarding UDP Broadcast Packets and Protocols 38-17
Establishing an IP Broadcast Address 38-17
Flooding IP Broadcasts 38-18
Monitoring and Maintaining IP Addressing 38-19
Enabling IP Unicast Routing 38-20
Configuring RIP 38-21
Default RIP Configuration 38-22
Configuring Basic RIP Parameters 38-22
Configuring RIP Authentication 38-24
Configuring Summary Addresses and Split Horizon 38-24
Configuring Split Horizon 38-26
Configuring Stub Routing 38-26
Understanding PIM Stub Routing 38-26
Configuring PIM Stub Routing 38-27
PIM Stub Routing Configuration Guidelines 38-28
Enabling PIM Stub Routing 38-28
Understanding EIGRP Stub Routing 38-29
Configuring EIGRP Stub Routing 38-30
