Filter
Top Products
7
Adjusting the monitor angle
You can adjust the angle of the monitor for best viewing.
Press one of ANGLE –/+ repeatedly.
The buttons adjust monitor position in discrete steps.
ANGLE –/+
+ button: Monitor is tilted backward.
– button: Monitor is tilted forward.
The adjustment is memorized, and the monitor will move
to the same angle the next time it is opened up again after
having been closed.
Closing the monitor
Press OPEN/CLOSE.
The monitor retracts into the unit, and you can use only the
audio functions of the unit (radio, CD, etc.). To turn all off,
press OFF.
OPEN/CLOSE
OFF
Shutting down
• If you press OFF on the card remote commander while
the monitor is opened up, the picture and sound are
turned off, and the unit switches to the standby mode, in
which only the clock indication is shown.
To turn on the unit when it is turned off, press SOURCE
on the unit. (You cannot turn on the unit with the card
remote commander.)
• If you set the ignition key of the car to OFF, power to the
unit is automatically turned off.*
Note
Do not move the monitor by hand.
Tip
If you have pressed OFF when opening
up the monitor, you can press SOURCE
to turn the picture on again.
Note
After the power was turned off, the
indicators on the front of the unit stay on
for another minute.
* Warning when installing in a car
without an ACC (accessory) position
on the ignition switch
After turning off the ignition, be sure to
press OFF on the unit for 2 seconds to
turn off the clock display.
Otherwise, the clock display does not
turn off and this causes battery drain.
Notes
• When the monitor is closed, MENU,
LIST, and ENTER on the card remote
commander cannot be used.
• If movement of the monitor during
opening or closing has been impeded
by the gear shift lever or another
obstacle, see “If movement of the
monitor has been impeded during the
monitor setting” (page 45).
• If OPEN/CLOSE was pressed while
the monitor was opening or closing,
the monitor may not stop at the
original angle. In such a case, press
ANGLE –/+ to adjust the angle.