Filter
Top Products
6
Preparations
Resetting the unit
Before operating the unit for the first time or after replacing
the car battery, you must reset the unit.
Use a pointed object such as a ball point pen to push the
Reset button. To avoid the possibility of damage, you
should not use a needle or push the button too strongly.
Push Reset.
Reset button
DISC
SEEK
SOURCE MODE AT T
OFF
OPEN/
CLOSE
.>
VOL
Opening up the monitor
Press OPEN/CLOSE on the monitor.
OPEN/CLOSE
The monitor slides out of the main unit, and the picture
comes on.
Notes
• When the Reset button is pushed, the
time and all stored settings are lost and
will have to be reprogrammed.
• The reset procedure takes about 10
seconds after the Reset button is
pushed.
• When the reset procedure is
completed, press OPEN/CLOSE and
verify that the monitor opens up
properly.
Notes
• The card remote commander cannot be
used for opening up or closing the
monitor.
• If movement of the monitor during
opening or closing has been impeded
by the gear shift lever or another
obstacle, see “If movement of the
monitor has been impeded during the
monitor setting” (page 45).
Getting Started