Filter
Top Products
58
GB
Using the Supplied Digital Voice Editor Software
(continued)
Recording dictation (using the voice recognition software)
•Set MIC SENS to DICT(L) (page 17).
•To transcribe a message recorded on the IC recorder using voice
recognition software (not supplied), set “MODE” to “ST,” or “SP” (page
50).
Microphone
•Before you can transcribe recorded messages, you have to create a user
file specifically adapted to the sound of your recorded speech. This
procedure is called “training.” For details on “training,” refer to the help
files supplied with the voice recognition software you are using.
•To obtain maximum recognition accuracy, hold the IC recorder so that
the microphone is about an inch (2 - 3cm) from the corner of your mouth.
•To minimize the sound of your breach in the recordings, do not hold the
microphone directly in front of your mouth.
•To obtain maximum recognition accuracy, avoid recording in a noisy
place.
•You cannot transcribe a message recording the voices of more than one
person.
•You can transcribe the following messages recorded using your IC
recorder or files saved on your computer.
– Messages recorded in the ST or SP mode (DVF)
– 44.1/16/11kHz 16-bit WAV files saved on the computer