Filter
Top Products
11
GB
Note on the “ACCESS” message
The unit is accessing data while “MEMORY STICK
ACCESS“ appears in the display window or the
OPR indicator flashes in orange. While accessing,
do not remove the “Memory Stick”, batteries, or the
AC adaptor (not supplied). Doing so may damage
the data.
Notes
•The unit starts accessing the data after it is turned on.
•If the unit is required to process excessive amount of data, “MEMORY STICK
ACCESS“ may be displayed for an extended period of time. This is not a
malfunction of the unit. Wait until the message disappears.
Removing the “Memory Stick”
Make sure that “MEMORY STICK ACCESS“ disappears, and turn off the
unit. Then open the “Memory Stick” slot cover and push the “Memory
Stick” into the slot, so that the “Memory Stick” pops out.
Remove the “Memory Stick” from the slot as shown below.
The types of “Memory Stick” you can use with this IC
Recorder
You can also use the following “Memory Stick” of a 4 MB to 128 MB
capacity instead of the supplied “Memory Stick Duo”. The maximum
recording time varies depending on the capacity of the “Memory Stick”.
•“Memory Stick”
•“Memory Stick (with memory select function)” (incorporating two
128MB memory units)
•“MagicGate Memory Stick”
•“Memory Stick Duo” (when inserted into the “Memory Stick Duo”
adaptor)
Notes
•The unit does not support the “Memory Stick PRO”.
•“MagicGate“ is a copyright protection technology that uses an encryption
technology. This unit does not support the MagicGate standard, and therefore,
recorded data using this unit is not subject to the protection of copyrights by
MagicGate.
Getting Started