Filter
Top Products
101
Additional Information
Symptom
There is no sound.
Sound is noisy.
The sound loses its stereo effect
when you play a VIDEO CD or a
CD.
The surround effect is difficult to
hear when you are playing a
Dolby Digital or MPEG sound
track.
The remote does not function.
Sound
Operation
continued
Remedy
• When you have made the connections using an audio
connecting cord and play DTS sound tracks, no sound
will come out (page 31).
• Check that the headphones plug connected to the
headphones jack is firmly connected to this player.
• Check that the VOL dial is not set to “MIN.”
• When you close the LCD panel, no sound will come
out from the built-in speakers.
• Clean the disc.
• There is a flaw on the disc.
• When you have made the connections using an audio
connecting cord and play a CD with DTS sound tracks,
sound noise will come out (page 31).
• Check that this player is placed in a horizontal position
and there is no mechanical vibration or shock.
• Set “AUDIO” to “STEREO” in the Control Menu
display (page 54).
• Make sure you connect the player correctly (pages 17,
20, 23).
• Check the speaker connections (page 23).
Refer to the operating manual of your receiver
(amplifier).
• Depending on the DVD, the output signal may not be
the entire 5.1 channels. It may be monaural or stereo
even if the sound track is recorded in Dolby Digital or
MPEG format.
• Remove any obstacles between the remote and the
player.
• Use the remote near the player.
• Point the remote at the remote sensor on the player.
• Replace all of the batteries in the remote with new ones
if they are weak.
• When using the battery pack, press POWER on the
player to turn on it.
• When using the battery pack and 10 minutes have
passed after turning off the player, you cannot turn on
the player with the remote.
• Make sure you use the supplied remote.