Filter
Top Products
GB
90
Troubleshooting
Page
34, 35
–
33-36
–
86
33
–
–
72
–
Problem Recommended Action
• Make sure the main power switch is in the
“OFF” position. The battery pack does not
charge when it is connected to the DVD player
while DVD player power is turned on.
• A warm battery takes longer than normal to
charge. Wait until the battery cools to normal
temperature before trying to charge it.
• Replace the battery pack with a charged one or
switch to AC adapter power.
• Charging of a battery pack may become
disabled (and the charge lamp may fail to light)
whenever heat from the DVD player causes the
internal temperature of an attached battery pack
to rise above certain level. When this happens,
remove the battery pack from the DVD player.
Charging will start automatically when battery
pack internal temperature drops to a safe level.
• Make sure the temperature of the battery pack
is within the allowable temperature range of
10°C to 30°C for charging.
• Check to make sure that the AC adapter DC
cable is connected correctly.
•
Try disconnecting the AC adapter DC cable from
the battery pack and then reconnecting it. If the
battery pack is attached to the DVD player, first
disconnect the battery pack DC cable from the
DVD player before performing the above step.
• Try charging another battery pack. The same
symptom occurring with another battery pack
may indicate a problem with the AC adapter. If
the other battery pack charges normally, it can
indicate a problem with the first battery pack or
that the first battery pack has reached the end
of its normal service life.
• Make sure the connected audio equipment is
turned on.
•
Check if linear PCM is selected as the audio mode.
•
When the space between tracks of some disks is
very short, two tracks can be recorded as a single
track, which causes a mismatch of track numbers.
• CD and MD track numbers may not match when
recording from a CD using programmed play or
direct skip.
Battery Pack Operation
The battery
pack does not
charge.
Power does
not turn on.
The battery
charge lamp
does not light
(the battery
pack does not
charge).
The battery
charge lamp is
flashing.
Cannot record to
an MD.
When recording from
a CD to an MD over
an optical digital
connection, the CD
track numbers and
MD track numbers
do not match.