Filter
Top Products
Chapter 3 Installing the StorNext Client
Installing the StorNext Client on Linux or Unix
StorNext 3.1.3 Installation Guide 48
4 List the packages extracted from the software archive file. At the
command prompt, type:
ls -l
Identify the correct package to install. The correct package begins
with
snfs and ends with the .bff file name extension.
5 Install the client software package. At the command prompt, type:
installp -ac -d <package name> all .
where <package name> is the name of the client software package you
identified in
step 4.
6 Edit the /usr/cvfs/config/fsnameservers text file to contain the IP
address of the MDC the client will connect to.
The fsnameservers file on the client must be exactly the same as on
the MDC. If the
fsnameservers file does not exist, use a text editor to
create it.
7 Create a mount point for the file system. At the command prompt,
type:
mkdir -p <mount point>
chmod 777 <mount point>
where <mount point> is the directory path where you want the file
system to be mounted. For example:
/stornext/snfs1
8 Configure the file system to automatically mount. At the command
prompt, type:
crfs -v cvfs -d <file system> -a verbose=yes -a type=cvfs -A yes -m <mount
point>
where <file system> is the name of the StorNext file system and <mount
point>
is the directory path created in step 7.
The StorNext file system is mounted at the mount point you
specified.
Note: The fsnameservers file only needs to contain the name of
the MDC. For example, if the MDC is named
snserver, then
the
fsnameservers file should contain a single line with a
single word:
snserver