Filter
Top Products
8
SilverBoom 300
www.silverstarlifts.com
III. INSTALLATION
The SilverBoom can be installed in either side of your
vehicle. The illustrations demonstrate installation on the
right side.
POWER ROTATING BASE SHROUD RE-
MOVAL
Installing a power rotating base requires that the base
shroud be removed in order to access the rear mounting
holes of the L-base. See figure 1.
1. Remove the 4 screws that secure the shroud to the
base.
2. Carefully lift the shroud up and off of the base.
NOTE: SilverBoom lifts that have a power rotat-
ing base should only be installed into a van or SUV.
DETERMINE L-BASE LOCATION
WARNING! The lift is heavy.
Assistance may be necessary during
installation. Use proper lifting
techniques and avoid lifting beyond
your physical capability.
1. Assemble the L-Base. See figure 2. For optimal
use, insert the base extensions into the L-base at
their farthest extension point and install the hardware
(nuts and bolts). The base extensions can be ad-
justed to accommodate obstructions.
NOTE: Always insert the bolt from the inside of
the L-base. This allows the base extensions to be
properly tightened without rattling.
2. Before permanently installing the lift, place the L-
base inside your vehicle in the area in which you in-
tend to install it. See figure 3 for L-base positioning
for SUV’s and vehicles with hatchbacks, or figure
4 for trunk installation.
NOTE: Positioning the L-base close to the rear
allows the boom-arm to stay as short as possible;
this enables the boom-arm to swing freely without
making contact with the motor vehicle.
Figure 3. L-Base (Hatchback Installation)
Figure 2. L-Base Extensions
BASE EXTENSIONS
NUT
L-BASE
BOLT 55 MM (2.5”)
Figure 1. Power Rotating Base Shroud Removal
SCREWS
SCREWS