Filter
Top Products
17SilverBoom 300
www.silverstarlifts.com
WARNING! Pinch/Crush Hazard!
Always keep hands clear of the lifting
strap while the SilverBoom is lifting/
lowering a mobility product. The
operator of the lift should stand a
safe distance away from the mobility
product being lifted/lowered to
ensure that feet are never positioned
under a raised mobility product.
Do not drag the mobility product into position using the
lift. If dragging occurs, your mobility product is too far
away from the vehicle. To prevent dragging:
" Release the lifting strap tension then remove the hook
from the docking device.
" Correct the position of the mobility product.
" Attempt the lift again.
MANDATORY! The SilverBoom 300 is
designed to lift a maximum weight
of 300 lbs (136 kg). Do not exceed
this limit.
7. If the mobility product begins to tilt, lower it com-
pletely and adjust the docking device by moving
the pick-up bar in the direction of the tilt (when
using a C-arm).
8. Tighten the pick-up bar once the proper balance point
has been found (when using a C-arm).
9. Once the mobility product is raised high enough to
fit into the vehicle, stop the lift. See figure 17.
Figure 18. Securing The Boom-arm
Figure 17. Lifting The Mobility product
IV. OPERATION
10. Swing the boom-arm toward the vehicle. When the mobility product is securely in the vehicle, lower the lift
strap until all of the mobility product’s wheels are on a solid surface.
11. If installed in a van or SUV, disconnect the hook from the docking device and attach it to the T-bar on the
base extension. (This prevents the boom-arm from swinging freely while the motor vehicle is in motion.)
Operate the lift in the upward direction until the strap is snug. See figure 18.
MANDATORY! Secure the boom-arm so it does not swing during transport. A swinging
boom-arm can be a hazard. If you cannot secure the boom-arm to prevent it from swinging
freely, remove the motor housing and lay it flat inside the vehicle.
WARNING! Do not overtighten the strap. Doing so may put excessive strain on the motor,
causing the circuit breaker to trip.
NOTE: If installed in a trunk, disconnect the black-red power harness (see figure 13 or 13A) and
remove the motor housing and upper post and place it in an area where it will be secure. The height of
the boom-arm will not allow the trunk to close.