Filter
Top Products
12
SilverBoom 300
www.silverstarlifts.com
III. INSTALLATION
NOTE: Choosing the correct length bolt allows enough bolt-thread to pass through the undercarriage,
ensuring enough room for the mounting washer and nut to be installed securely.
6. From under the vehicle, install the mounting washers and nuts to all five (5) mounting bolts and tighten. See figure 10.
NOTE: The holes in the mounting washers are for working around obstructions. Choose the hole that
best works in the area you are installing the mounting bolts.
7. Place the L-base cap over the L-base and secure it with the supplied screws. See figure 11. Replace the base
shroud for power rotating base models.
8. Reinstall the upper post.
NOTE: When inserting the upper post into the power rotating base, a slight adjustment of the sprocket
may be needed to align the insertion hole with the lower post located inside the power rotating base. This
can be done by inserting the upper post into the sprocket and moving it until it descends into the power
rotating base’s lower post.
9. Reinstall the motor housing and make adjustments as necessary.
The lift is now fully assembled. See figure 12.
Figure 10. Securing The L-Base
T-BAR
MOUNTING BOLTS
2” (50 MM) OR 3” (75 MM)
MOUNTING WASHER
NUT
WASHER
MOUNTING HOLE