Filter
Top Products
16
SilverBoom 300
www.silverstarlifts.com
LIFTING THE MOBILITY PRODUCT
WARNING! Before operating the
SilverBoom for the first time, be
absolutely certain you have the proper
docking device for your mobility product.
1. Prepare your mobility product for transport. Ensure
that the power is off or key is removed and properly
secure the batteries. You may also need to lower the
tiller and/or remove the seat.
2. Position your mobility product on the ground behind
the installed lift. Be sure that there is ample space
between the mobility product and the vehicle bumper
to ensure that the mobility product will not hit the
bumper while being raised. If the mobility product is
too far from the vehicle’s bumper, the mobility prod-
uct will be dragged when attempting to lift it.
3. Position the boom-arm over the mobility product.
4. Operate the lift (via the hand/remote control in the
downward direction until the lifting hook reaches
the T-bar. The lift strap should drop straight down
to the T-bar. See figure 15.
Figure 16. Lifting Strap Warning Label
DOCKING DEVICE T-BAR
LIFTING HOOK
Figure 15. Lifting Hook Placement
IV. OPERATION
WARNING! Inspect the lifting strap before each use for twisting, fraying, and signs of wear.
" Keep tension on the lifting strap with your free hand when lowering the lifting hook.
" Lower the lifting hook only to the T-bar of the docking device.
WARNING! Do not extend the lifting strap past the warning label located on it. See figure 16.
5. Place the lifting hook onto the docking device T-bar. See figure 15.
6. Operate the lift in the upward direction.
Remote Control Battery Replacement
As with all electronic devices powered by batteries, the
battery of the remote control will eventually need to be
replaced. When the lift responds intermittently or no
longer responds to the commands from the remote
control, replace the battery.
To replace the batteries of the remote control:
1. Loosen and remove the screws from the back of the
remote control.
2. Remove the old battery. The battery slides in and
out from the side. Do not lift the battery straight up.
3. Replace old battery with one of the same size
(CR2430 3-volt).
4. Reassemble the remote control.