Filter
Top Products
19
En
CONNECTIONS
MANIPULATOR STYLE CONNECTIONS
These connections should be used when you wish to operate the accessory DJS or other DJ software without connecting the drive unit.
Use the accessory USB auxiliary power cable and the normal USB cable to connect the control unit to the computer (connect the USB
auxiliary power cable first).
NOTE
• When making manipulator style connections, do not connect the drive unit, since it will not function correctly.
• Do not connect anything to the 5 V connector other than the accessory USB auxiliary power cable.
• Always use the accessory USB auxiliary power cable and USB cable only.
• Always connect the accessory USB auxiliary power cable and USB cable to one and the same computer.
• Do not connect this unit to a computer through a USB hub.
• Do not connect this unit to a computer through a CardBus-supported USB interface card.
REMOTE
CONTROL
PC
MONITOR OUT
5V
Do not connect until you have installed the required driver
in your computer. See “ABOUT THE DRIVER PROGRAM”
(P.50).
Control unit
Accessory USB cable
Accessory USB auxiliary
power cable.
Computer
Audio interface (sold separately)
Audio cable
Mixer
MEP-7000_EN.book 19 ページ ２００８年３月３日 月曜日 午後９時１７分