Filter
Top Products
EN 87
CORRECTIVE ACTION
Set the clock and/or timer correctly.
Press TIMER and check to make sure
that ‰ appears on the front display
panel.
Re-perform the set-up procedures.
Make sure you have compensated for
Guide Channel and recorder or cable
box channel number mismatches
(੬ pg. 56).
Timer programming can’t be performed
when timer recording is in progress.
Wait until it finishes.
VHS deck
Load a cassette with the Record
Safety tab intact, or cover the hole
using adhesive tape.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the Record Safety tab
intact.
Remove the cassette and set the erase
protection switch to “REC”.
Check the programmed data and re-
program as necessary, then press
TIMER again.
The program may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire program.
SYMPTOM
1. Timer recording won’t work.
2. Timer programming won’t work.
3. ‰ and ] on the front display
panel won’t stop blinking.
4. The cassette is automatically
ejected, and ‰ and ] on the
front display panel won’t stop
blinking.
5. ‰ blinks for 10 seconds and the
timer mode is disengaged.
6. The cassette is automatically
ejected, the power shuts off and ‰
and ] won’t stop blinking.
POSSIBLE CAUSE
● The clock and/or the timer have
been set incorrectly.
● The timer is not engaged.
● The recorder has not been set up
properly.
● Timer recording is in progress.
● The timer is engaged but there’s no
cassette loaded.
● VHS deck
The loaded cassette has had its
Record Safety tab removed.
● TIMER has been pressed when there
are no programs in memory, or the
timer record program information
has not been programmed correctly.
● The end of tape was reached during
timer recording.
TIMER RECORDING
CONTINUED ON NEXT PAGE
SYMPTOM
5. Audio dubbing is not possible.
7. When performing Tape Dubbing,
the beginning of the dubbing start
point is not dubbed.
RECORDING
POSSIBLE CAUSE
● The tape speed had been set to LP at
the original recording.
● HDD deck
This is normal. Audio dubbing is not
available for HDD deck.
● This is normal.
CORRECTIVE ACTION
Set the tape speed to SP at the
original recording.