Filter
Top Products
Getting Started (Hookups)
19
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the remote, a
plastic cover pushes off in the direction shown by the arrow. Remove this cover and
install the batteries, matching the plus end of each battery with the plus mark on the
remote.
7 Set the RF or Video Channel Switch
When the VCR is on, its video signal can come into your TV an either channel 3 or
channel 4. You need to select the appropriate channel.
• Turn the power on to both the TV and the VCR, and look for a switch on the back of
the VCR. Set the switch to 3 or 4, whichever is not a commercial channel in your area.
Your basic hookup is now complete. When you're ready to try hooking up a second
VCR or a video camera, see Advanced Operations.
Now turn the TV and VCR back around facing you and begin your quick tour of the
controls (page 14).