Filter
Top Products
Getting Started (Hookups)
18
300 ohm flat UHF and 75 ohm
round VHF
If you have "rabbit ears" (an antenna on top of your TV), you will need an additional
adapter and 75 ohm extension to make your leads reach from the antenna to the VCR.
This connection will work only if you have a strong, clear picture on the TV, indicating a
strong signal. Connect the antenna to the adapter, and use the cable extension to go
from the adapter to the VCR. Use the supplied 75 ohm cable to connect the VCR to the
TV.
Now continue wit the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the
IN FROM ANT. lower jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO
TV upper jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the
TV (where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions
provided by this equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord
or surge protector. See Important Safeguards for further precautions (page 6).