Filter
Top Products
18
19
Wireless LAN setup: Before conguring the wireless network, insert the USB Wireless
Adapter into one of the USB 2.0 ports on the front of the mp200.
To setup the wireless connection, the mp200 will walk you through the steps below.
During each step, you can press the “OK” button to continue, or press the “RETURN”
button to go back to the previous step.
Connection
Profile
Peer to Peer
Ad Hoc
Infra AP
Get SSID
(Scan WLAN)
1. Setup SSID
2. Security
Enter the key
Enter the key
DHCP
FIX IP
FIX IP
Wireless
Wireless Setup
Security Setup
IP Setup
Profile
OK
OK
Prole: Choose one prole to edit or apply. The saved prole can be applied later. To
apply the prole, choose it and press blue button to apply. In the rst setting, choose
“Connection 1” and press the “OK” button to continue.
Connection: Select to use either the “Infrastructure (AP)” or “Peer to Peer (Ad Hoc)”
modes. If you have a home router, you would typically choose “Infrastructure (AP)”.
If your home network does not include a router, then choose “Peer to Peer (Ad Hoc)”
mode.
The following wireless setup procedure is divided into two sections, depending on which
mode your wireless network uses (Infrastructure/AP vs. Peer to Peer/Ad Hoc).