Filter
Top Products
16
Adjusting brightness
Screen brightness affects battery life. Dim the screen to extend battery life.
TO ADJUST SCREEN BRIGHTNESS
1. Select → Device Options → Brightness.
2. Touch the marker to the right to increase brightness incrementally or to the left to reduce
brightness. You can also press and drag the slide in either direction.
NOTE
The FLO TV™ Personal Television has an ambient light sensor and
automatically adjusts lighting to current light levels. Adjusting brightness
levels adjusts the base light level for the ambient light sensor under
current lighting conditions.
Adjusting the volume level
To increase or decrease the volume one level at a time, use one of the following methods:
• Press the Volume Up or Volume Down button located on the right panel of the FLO TV™
Personal Television.
• Press and hold the Volume Up or Down button to continuously increase or decrease the
volume level.
Sleep mode
When the power is on and you temporarily do not need to use the FLO TV™ Personal Television,
you can save battery power by entering into Sleep mode by briefly pressing the Standby/Power
button.
When the FLO TV™ Personal Television is in Sleep mode, the touch screen and FLO TV™ Personal
Television buttons, except for the Standby/Power and Battery Level buttons, are locked and
unresponsive when pressed.
Briefly press the Standby/Power button to wake up the FLO TV™ Personal Television and touch
the wake-up button on the screen. The FLO TV™ Personal Television resumes playing the channel
prior to entering Sleep mode.
NOTE
Wireless radios are not turned off when the FLO TV™ Personal Television
goes into Sleep mode. Device reset is still possible while in Sleep mode,
using the power button and the Guide key.
Audio-only mode
Audio-only mode turns off the display and allows you to continue listening to audio. Start by
viewing a television and then double-press the Sleep/Power button to enter audio-only mode.
The touch screen is locked when the FLO TV™ Personal Television is in audio-only mode. Losing
and reacquiring the signal does not cancel audio-only mode.
To turn on the display again without disrupting the audio, briefly press the Standby/Power
button.