Filter
Top Products
CONVENTIONAL MODE OPERATION
The procedures in the following section describes Conven-
tional Mode operation. Each conventional channel may be
programmed with one or more features such as Channel Guard
or telephone interconnect capability. Follow these procedures
if operating in a conventional system.
RECEIVING A MESSAGE
1. Turn the radio on by sliding the ON/OFF switch on the battery pack, to
the
ON
position. A yellow area will be visible on the battery. After the
radio has passed the power-up self test an optional tone will sound and
the current System and Group/Channel will be displayed. If the unit
does not pass the test, the display will be blank.
2. Press the
SHIFT/CLR
button and then use the
SELECT
buttons s or
t to select a Conventional system. The SYStem display will indicate
the current System selected.
3. Use the
SELECT
buttons s or t to select the desired Channel. The
GRP icon will be surpressed but the field will still display the channel.
The radio is now ready to receive messages.
4. Press the
SHIFT/CLR
button twice ("double click") to disable squelch
and monitor the channel. Adjust the
VOLUME
buttons to the desired
audio level.
5. When a message is received (and the correct Channel Guard signal
is decoded, if programmed and enabled) the receiver will unsquelch
and the message will be heard.
57