Filter
Top Products
channel is found, the radio will switch to the new system and sound an alert
tone. Group selection may change upon switching to the new system.
The radio may also be programmed for priority wide area system scan.
A priority system may be assigned to each system programmed into the radio.
Radios programmed in this manner will scan the priority trunked system’s
control channel once every one, two, three or four minutes (programmable).
This priority scan timer is reset each time the PTT bar is pressed.
DYNAMIC REGROUPING (Optional)
Dynamic Regrouping is a feature which allows the System Manager to
dynamically program new groups into selected radios. Upon development
of the regrouping plan, the site controller sends each radio the regroup plan
number, "group position", and activate/deactivate commands. When the
radio is regrouped, it will alert the user and the Group field will will display the
regroup number "nn" (nn = 01-08).
DTMF OVERDIAL
After the radio has acquired a working channel to make a message
trunked call, DTMF tones can be sent by:
1.
Pressing and holding the PTT bar.
2.
Manually entering the desired numbers from the keypad.
In the same manner, stored interconnect numbers (tones) may
be sent by:
1.
Recalling the desired storage location as described previously in the
Recalling Manually Stored Individual and Interconnect Numbers
section.
2.
Pressing the PTT bar to send the tones.
The regroup is identified by the leading zero in the 10’s digit of the
Group field. This zero is normally surpressed in Groups 1-8.
NOTE
37