Filter
Top Products
number from the special call list, if no special calls are programmed
then this field will be blank. Note this display is similar to the Special
Call mode display except the "S" and "PC" icons are not illuminated.
2.
The programmed call may now be sent following the procedure de-
scribed in the section for the S
CAN Model Radio.
Sending A Manually Entered Individual Call
1.
Press the SPC key to put the radio into Special Call mode or "7" to put
the radio into Conference Call mode. The SYStem field will display
"SP" and the GRP (Group) field will display the last accessed call
number from the preprogrammed Special Call selection. or will be
blank if no Special Calls are programmed for this area. If the radio
was put into Special Call mode the "S" and "PC" icons will be illumi-
nated and if the radio was put into Conference Call mode the icons will
be off.
2.
Enter the tone set of the radio to be called. The first digit entered will
cause the System field and the 10’s digit in the Group field to blank.
The last digit entered will always be displayed in the 1’s digit of the
Group display. Any previously entered digits will scroll left. Only four
characters will be visible at a time with the leading character scrolling
off the display upon each new key entry.
3.
Complete the tone set entry by pressing the # key. The # key indicates
the digits entered are for an individual call. This will not be displayed
but a tone will sound.
To recall the last individual number entered manually from the
key pad, press and hold the SHFT/CLR button and then press
the RCL key.
NOTE
45