Filter
Top Products
1.
Press the SPC key to put the radio into Special Call mode to send the
stored call using the programmed special call tone set, otherwise the
call will be sent using the selected group tone set. Press the # key to
recall the individual call list or the * key to recall the interconnect call
list. The screen will blank and a tone will sound.
2.
Enter the desired storage location number (0-9).
3.
Press the
RCL (shifted #) key If the number is from the individual call
list the last four digits of the tone set will be displayed. If the number
is from the interconnect call list, the last four digits of the telephone
number will be displayed.
If the memory location is blank the radio will sound a low pitch tone
after the
RCL is pressed.
4.
Individual - Once the desired individual call number is displayed , press
and release the PTT to initiate the call. The radio performs the
necessary signalling required to obtain a working channel.
Interconnect - Once the desired interconnect special call number is
displayed,, press and release the PTT to initiate the call. The radio
performs the necessary signalling required to obtain a working chan-
nel.
5.
Individual - When the signalling is successfully completed the "BSY"
flag turns on and the Call Originate tones (three alert tone) sound.
Press the PTT bar and speak directly into the microphone. Release
the PTT bar as soon as you stop talking and wait for a reply.
Interconnect - When the signalling is successfully completed the
"BSY" flag turns on and the proper DTMF tones will be sent and heard
at the speaker. When someone answers, press the PTT bar and speak
directly into the microphone. Release the PTT bar as soon as you stop
talking. Messages cannot be received when the PTT bar is pressed.
6.
The radio is out of range or the radio is inoperative when the signalling
is unsuccessful, the "NO" and "SV" indicators are illuminated and a
sequence of five beeps are heard at the speaker. Any subsequent
attempt to initiate a call within the next 20 seconds will be ignored. The
radio can be cleared from this mode by double clicking the SHFT/CLR
button.
50