Filter
Top Products
36
The DSM-320 Setup Wizard (continued)
Select the SSID (network
identifier) that is being used by
your wireless network. To select
an SSID, press ENTER on the
remote control while the SSID
window is highlighted. Use the
up arrow and down arrow
buttons on the remote control to
navigate through the list. Once
you’ve highlighted the correct
SSID, press ENTER on the
remote control. Press the down
arrow on the remote control to navigate to the Next button.
The Rescan button will refresh the list of available networks. Use the left arrow
and right arrow to navigate from the Next button to the Rescan button. If you
cannot locate the SSID, select <Manually Enter SSID> and you will be able to
enter it on the next screen.
Select the SSID
The connection type defaults to
Wireless.
Select Your Network Connection
Wireless
If using a wireless network,
press the down arrow on the
remote control to navigate to the
Next button. Once the Next
button is highlighted, press
ENTER on the remote control
to proceed to the next screen.
Wired
To select Wired, press the ENTER button on the remote control while the
Connection is highlighted. Press the up arrow on the remote control to choose
Wired. Press ENTER again to make the selection and then press the down
arrow on the remote control to navigate to the Next button. Once the Next
button is highlighted, press ENTER on the remote control to proceed to the
next screen. Skip to the Current Network Settings screen on page 38.