1-4 SDC755A
1 • Introduction
Safety
The equipment is supplied with a moulded mains lead and plug
which should be used. If the lead cannot be used as supplied for any
reason, the following information applies:
1. An approved mains lead for the country concerned must be
used.
2. As the colours of the wires in the mains lead of this equipment
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
- The wire which is coloured green and yellow must be connected
to the terminal in the plug which is marked with the letter “E” or
by the earth symbol or coloured green or green and yellow.
- The wire which is coloured blue must be connected to the
terminal which is marked with the letter “N” or coloured black.
- The wire which is coloured brown must be connected to the
terminal which is marked with the letter “L” or coloured red.
3. The wires in the supplied mains lead are coloured in accordance
with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
WARNING:
THIS EQUIPMENT MUST BE EARTHED
The socket outlet should be near to the
equipment and should be easily accessible.
To comply with health and safety standards, operators must observe
all local standard safety precautions relating to the operation of office
equipment. In particular, DO NOT remove covers from the machine.
Refer all servicing to qualified personnel.
Keep hands, jewellery, ties, long hair, etc. away from moving parts.
If you are in any doubt at all about your ability to safely do such work,
you should consult a qualified electrician.
