85
V5.1‐March2010
MEASURING CAPACITANCE
To measure Capacitance, refer to the following:
1. Insert the black lead into the COM jack, and the red lead into the V/Ω/C jack
2. Press the R key. An ‘R’ appears at the top of the screen
3. Press the SET key until the C appears at the top of the screen
4. Connect the black and red leads to the capacitor or circuit under test; the
meter will display the reading (Unit of measure: Farad)
Notes: To improve accuracy when the measured value is lower than 5 nF, select the
lowest capacitance range and use the Relative mode.
Please allow approx. 30 seconds for capacitance measurements larger than 40uF.
Refer to the example diagram in Figure 5.
Figure 5: Capacitance Measurement
MEASURING DC VOLTAGE
To measure DC voltage, refer to the following:
1. Insert the black lead into the COM banana jack input and the red lead into
the V/Ω/C banana jack input
2. Press the V key and the DCV symbol will appear at the top of the screen
3. Connect the red and black test leads to the measurement points on the
circuit under test; the voltage value will be displayed on the screen
Refer to the example diagram, Figure 6.
