22
V5.1‐March2010
USINGTHEAVERAGEMODETOSMOOTHWAVEFORMS
Use the Average mode to smooth the displayed waveform; multiple data samples will
be averaged. The number of samples to average is selectable from 4, 16, 64, up to
128.
Note: For best results, the waveform must be repetitive. As the number of average
samples increases the waveform updating time increases. Refer to the following:
1. Press the MENU key; the function menu will appear on the right side of the
screen.
2. Press MENU ▲ or MENU ▼ to select the ACQU (acquisition) mode; Four (4)
selectable options will display at the bottom of the screen.
3. Press the F3 key to select Average Factors and then press the F4 key to jump
to Averages 16. The meter then averages 16 samples (or acquisitions) and
displays the final result. Refer to Figure 13:
Figure 13: Average Factor Sampling Mode
PERSISTENCEMODE(SUPERIMPOSINGWAVEFORMS)
Persistence Mode allows the user to hold a displayed waveform on the display while,
at the same time, superimposing the current waveform. The user can select the
amount of time (number of seconds or infinite) to retain the displayed waveform
or set the feature OFF. Refer to the following:
