A SERVICE OF

logo

30
V5.1‐March2010
The following Table describes the Vertical Channel menu:
Function
menu
Setting
Description
Coupling
AC
DC
The dc component in the input signal is blocked
The ac and dc components of the input signal are available
Channel
OFF
ON
Close the channel
Open the channel
Probe
1X
10X
100X
1000X
Select the desired probe attenuation
Inverted
OFF
ON
Waveform is displayed normally
Open the Invert function for the waveform setting
SETTING THE CHANNEL COUPLING
CH1 will be used in this example.
Press F1 Coupling and then AC to set AC coupling. The DC component contained
in the tested signal is blocked.
Press F1 Coupling and then DC to set DC coupling. Both DC and AC components
contained in the tested signal are permitted.
Refer to Figures 20 and 21.