2-473
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port debounce
set port debounce
To enable or disable the debounce timer or configure the timer setting on a per-port basis, use the set
port debounce command.
set port debounce mod/port {enable | disable}
set port debounce mod/port delay time
Syntax Description
Defaults By default, the debounce timer is disabled on all ports.
When the debounce timer is disabled, the default debounce timer values are as follows:
• 10BASE-FL ports—300 milliseconds
• 10/100BASE-TX ports —300 milliseconds
• 100BASE-FX ports—300 milliseconds
• 10/100/1000BASE-TX ports—300 milliseconds
• 1000BASE-TX ports—300 milliseconds
• Fiber Gigabit Ethernet ports—10 milliseconds
• 10-Gigabit Ethernet ports—10 milliseconds
When the debounce timer is enabled, the default debounce timer values are as follows:
• 10BASE-FL ports—3100 milliseconds
• 10/100BASE-TX ports —3100 milliseconds
• 100BASE-FX ports—3100 milliseconds
• 10/100/1000BASE-TX ports—3100 milliseconds
• 1000BASE-TX ports—3100 milliseconds
• Fiber Gigabit Ethernet ports—100 milliseconds
• 10-Gigabit Ethernet ports—100 milliseconds
Command Types Switch command.
Command Modes Privileged.
mod/port Number of the module and the port on the module.
enable | disable Enables or disables the debounce timer.
delay Sets the debounce timer for gigabit fiber ports.
time Amount of time the firmware waits before notifying the supervisor engine of a link
change; valid values are 200 milliseconds or from 300 to 5000 milliseconds. This
is supported on gigabit fiber ports only. See the “Usage Guidelines” section for
more information.
