2-12
Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
78-19417-01
Chapter 2 Card Reference
ML-100T-8 Card
2.4.1 CE-MR-6 Card-Level Indicators
The CE-MR-6 card faceplate has two card-level LED indicators, described in Table 2-6.
2.4.2 CE-MR-6 Port-Level Indicators
The CE-MR-6 card has an LED for each of the six ports, described in Table 2-7.
2.5 ML-100T-8 Card
This section describes the features and functions of the Layer 2 10/100 Ethernet card, the ML-100T-8.
The card is compatible with the ONS 15310-MA SDH.
Note The ML-100T-8 card with PID 15310-ML-100T-8 is not compatible with the ONS 15310-MA SDH.
15310-P-ML-100T-8 is compatible with the ONS 15310-MA SDH shelf assembly. If you install a
15310-ML-100T-8 in an ONS 15310-MA SDH shelf assembly, you will receive a mismatched
equipment alarm (mismatchofEquipment). You can view the PID under the node view Inventory tab in
CTC.
Table 2-6 CE-MR-6 Card-Level Indicators
Card-Level LEDs Description
FAIL LED (Red) The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the CE-MR-6 card. As part of the
boot sequence, the FAIL LED blinks until the software deems the card
operational, then it turns off.
ACT/STBY LED
(Green)
The ACT/STBY LED provides the operational status of the CE-MR-6. When
the ACT/STBY LED is green, it indicates that the CE-MR-6 card is active
and the software is operational; otherwise, it is off.
Table 2-7 CE-MR-6 Port-Level Indicators
Port-Level Indicators Description
Off No link exists to the Ethernet port.
Steady amber A link exists to the Ethernet port, but traffic flow is inhibited. For
example, a lack of circuit setup, an error on the line, or a disabled port
might inhibit traffic flow.
Solid green A link exists to the Ethernet port, but no traffic is carried on the port.
Flashing green A link exists to the Ethernet port, and traffic is carried on the port. The
LED flash rate reflects the traffic rate for that port.
