8-39
Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
78-19417-01
Chapter 8 Management Network Connectivity
TCP/IP and OSI Networking
8.6.8 Provisioning OSI in CTC
Table 8-14 shows the OSI actions that can be performed in CTC using the node view Provisioning tab.
Refer to the Cisco ONS 15310-MA SDH Procedure Guide for OSI procedures and tasks.
Table 8-15 shows the OSI actions that can be performed in CTC using the node view Maintenance tab.
Table 8-14 OSI Actions from the CTC Node View Provisioning Tab
Tab Actions
OSI > Main Setup
• View and edit Primary Area Address.
• Change OSI routing mode.
• Change LSP buffers.
OSI > TARP > Config Configure the TARP parameters:
• PDU L1/L2 propagation and origination.
• TARP data cache and loop detection buffer.
• LAN storm suppression.
• Type 4 PDU on startup.
• TARP timers: LDB, E1, T2, DS3/E3, T4.
OSI > TARP > Static TDC Add and delete static TARP data cache entries.
OSI > TARP > MAT Add and delete static manual area table entries.
OSI > Routers > Setup
• Enable and disable routers.
• Add, delete, and edit manual area addresses.
OSI > Routers > Subnets Edit RS-DCC, MS-DCC, and LAN subnets that are provisioned for
OSI.
OSI > Tunnels Add, delete, and edit Cisco and IP-over-CLNS tunnels.
Comm Channels > RS-DCC
• Add OSI configuration to an RS-DCC.
• Choose the data link layer protocol, PPP or LAP-D.
Comm Channels > MS-DCC
• Add OSI configuration to an RS-DCC.
Table 8-15 OSI Actions from the CTC Maintenance Tab
Tab Actions
OSI > ISIS RIB View the IS-IS routing table.
OSI > ESIS RIB View ESs that are attached to ISs.
OSI > TDC
• View the TARP data cache and identify static and dynamic entries.
• Perform TID to NSAP resolutions.
• Flush the TDC.
