Filter
Top Products
MM23772, Rev. B
73
select/entry mode remains active until the call is dropped, cleared, or is pressed. The overdial
select/entry mode can be re-entered if the call is still active by pressing
.
P7270 Model Radio:
1. Follow the procedure in Section
8.24.2 to establish a connection to the telephone system or consult
the system administrator for the procedure to access a dial tone on the trunked or conventional
system.
2. Overdial numbers are transmitted using either method as follows:
This overdial select/entry mode remains active until dropped, cleared, or
is pressed. The overdial
select/entry mode can be re-entered if the call is still active by pressing
.
8.25 PROGRAMMABLE ENTRIES
8.25.1 Pre-Storing Individual and Telephone Interconnect Calls from the
Keypad
Individual Call ID numbers, telephone numbers and other number sequences for overdialing are stored in
the special calls lists when programming the radio. The first ten entry locations of these lists can be
changed by the radio operator. The keypad is used when adding, changing, and storing numbers in these
entry locations.
Use the following procedure to store a number in one of the first ten entries of a special call list:
1. Press
or to enter the individual call list or the phone call list. is displayed.
2. Scroll through the list using the or until one of the first ten entries is reached. NO ENTRY is
displayed if the location is empty.
3. Enter the desired number. If necessary, a pause can be entered by pressing and holding 0-9,
, or
until an underscore appears in the display (telephone interconnect only). The individual call list
entries will accept up to 5 digits. The phone call list entries accept a combination of up to 31 digits
and pauses.
4. Press and hold
until the display changes indicating that the number has been stored.
Repeat steps 1-4 above if the number stored in an entry location needs to be changed.
8.26 STATUS/MESSAGE OPERATION
Status operation permits the transmission of a pre-programmed status condition to the P25 Trunked or
EDACS site. Message operation permits the transmission of a pre-programmed message text to a P25
Trunked or EDACS site.
8.26.1 Status Operation
To send a status condition, press the key followed by or key to select the pre-programmed
status. STATUS and 0 through 9 pre-programmed status selections are available from the menu. If
STATUS is selected you need to enter the number of the status message you intend to transmit. If no
status has been programmed for the selected number key, the radio will display NO ENTRY. A valid
selection will permit the status text to appear in the display for a pre-programmed time. After the time-out