Filter
Top Products
MM23772, Rev. B
55
MESSAGE NAME DESCRIPTION
TXEMER
Transmit
Emergency
Indicates an emergency call has been transmitted on this radio. This
message will be flashing on line two.
VOL=31
Volume Level Indicates the current volume level. The volume level display ranges
from OFF (silent) to 31 (loudest).
WHC
Who Has
Called
Indicates an individual call has been received, but not responded to. The
indicator turns OFF if the individual call mode is entered, the system is
changed, or the radio is turned off and then on again.
UNKNOWN
Unknown ID Indicates an individual call is being received from an unknown ID.
8.7 ERROR MESSAGES
If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs
servicing.
DSP ERR
ERR=XXXX
(PowerUp
only)
or
DIG V x
ERR x
Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.
8.8 ALERT TONES
The P7200 radio provides audible Alert Tones or “beeps” to indicate the various operating conditions (see
Table 8-2).
Table 8-2: Alert Tones
NAME TONE DESCRIPTION
Call Originate
one short mid-pitched
OK to talk after pressing the push-to-talk
button
Call Queued
one high-pitched
Call queued for processing
Autokey
one mid-pitched
Queued call received channel assignment
System Busy
three low-pitched
System busy or unable to complete call
Call Denied
one low-pitched
Radio is not authorized on the system or
group
Carrier Control
Timer
five high-pitched/one long low-
pitched
PTT depressed for maximum length of time
Low Battery
one low-pitched/one short mid-
pitched
Low battery
TX Low Battery
Alert
one low-pitched
After PTT - battery too low to transmit