Filter
Top Products
MM23772, Rev. B
102
10.6 TURNING ON THE RADIO
1. Power ON the radio by rotating the POWER ON-OFF/VOLUME knob clockwise. A short alert
signal (if enabled through programming) indicates the radio is ready to use. Refer to
Figure 10-1 for
location of the POWER ON-OFF/VOLUME KNOB.
2. The display shows the last selected system and group or a default system and group (depending on
programming).
3. Adjust the POWER ON-OFF/VOLUME knob to the desired volume level.
4. Select the desired system and group. The display indicates the current system and group names.
5. The radio is now ready to transmit and receive calls.
10.7 SYSTEM SELECTION
METHOD 1:
From the control knob: If system selection is programmed to the
SYSTEM/GROUP/CHANNEL SELECTION control knob, select a system
b
y turning
the knob to the desired system number position (1-16). The display registers the new
system name on line one. The
button can be programmed to provide access to a
“2
nd
bank” of 16 system number positions (17-32)
METHOD 2: (System and Scan model radios only) From the keypad: If system selection is
programmed as the primary function of
and , select a system by pressing
or to scroll through the system list. The display registers the new system name on
line one.
METHOD 3:
(System model radios only) Direct Access: Press
to enter the system select mode.
Press the numeric key, which is mapped to the desired system. Press
. The radio will
move to the selected system.
METHOD 4:
(Select model radios only) If programmed, press the
button to scroll through an
d
change systems. The display registers the new system name on line one.
If system selection is programmed to the SYSTEM/GROUP/CHANNEL knob, direct
access to systems will not be available. Pressing or will scroll through different
sets of 16 systems each (banks) if more than 16 systems are programmed into the
radio. The systems within each bank are then selectable via the
SYSTEM/GROUP/CHANNEL knob as described previously in METHOD 1.
Example:
System: 1 = North Group: 1 = Group 1
2 = South 2 = Group 2
3 = East 3 = Group 3
4 = West 4 = Group 4
Press
. (South is the currently selected system.)
Press
. (Press 4 to select “West” system.)
Press
. (West is the newly selected system.)