Filter
Top Products
78
PORTABLE DATA
The LPE-200 radios, when operating in the
EDACS configuration, permit either voice or data
calls to be transmitted or received. The radio can
handle only one type of call at a time; however,
selection of either data or voice is selected
transparently by the operator through normal usage
of the radio. Data communications is not supported
in the conventional mode.
The radios can be connected to Mobile Data
Terminals (MDT) or to a host computer. Any RS-232
compatible device that supports the Radio Data
Interface (RDI) protocol (Version 1.91 or greater)
may be connected to the radio. Support for MDT's or
host computers is a programmable option per radio.
Additionally, radios may also be programmed for
data only operation (no voice calls transmitted or
received).
DISPLAYS
The following will be displayed in the display
during the various states of data mode of operation.
TX DATA
Displayed on top line of display when
the radio is transmitting a data call.
RX DATA
Displayed on top line of display when
the radio is receiving a data call.
DATA OFF
Displayed on top line of display when
the radio is in the data disabled state.