Filter
Top Products
39
declared scanning will stop and restarts only after
the emergency has been cleared.
Receiving an Emergency Call
When receiving an emergency call on the
selected group and system, an alert beep is heard
and
comes on. The message
*RXEMER* flashes
in the display on line two until the emergency
condition is cleared.
Declaring an Emergency Call
To send an emergency call to selected system
and group (or on an optionally preprogrammed
group), proceed as follows:
1. Press and hold the red EMERGENCY button
that is on top of the radio in front of the antenna
for approximately one second (this time is
programmable and therefore could be longer or
shorter; check with the system administrator).
The radio will transmit an emergency call
request with the radio ID until an emergency
channel assignment is received.
2. When the working channel assignment is
received, the radio sounds a single beep
indicating the radio has auto keyed (see Auto
Key) and is ready for voice transmission.
*TXEMER* flashes on line two in the display until
the emergency is cleared.
3. Press PTT and speak into the microphone in a
normal voice.
and momentarily turns on.