Filter
Top Products
43
SYSTEM Model Radios
1. With scan operation turned off, select the
desired group to add to the selected trunked
system group scan list.
2. Press 6. The current priority status of the
group will be displayed in column 10 of line three
for a time-out period. If the group is not part of
the scan list the status will be blank.
3. While the status is displayed, press 6 to add
the group to the scan list.
is displayed on line
three.
4. Press 6 a second time to set the group to
Priority 2. A
is displayed on line three.
5. Press 6 a third time to set the group to
Priority 1. A
is displayed on line three. The
priority level selection sequence only advances
the group to next higher priority level and stops
at priority level 1. To select a lower priority level,
the group must be deleted from the scan list and
then added back to the scan list. Each new
group added to the scan list starts at the lowest
priority. If the Priority 1 and Priority 2 groups are
already set and a new group is assigned as
Priority 1 or Priority 2, the previously assigned
group will change to non-priority scanning. One
of the following messages may be momentarily
displayed:
SCAN DIS
The radio is not programmed to scan.