Filter
Top Products
42
5. Press A a third time to set the group to
Priority 1. A
is displayed on line three. The
priority level section sequence only advances the
group to the next high priority level and stops at
priority level 1. To select a lower priority level,
the group must be deleted from the scan list and
then added back to the scan list. Each new
group added to the scan list starts at the lowest
priority. If the priority 1 and Priority 2 groups are
already set and a new group is assigned as
Priority 1 or Priority 2, the previously assigned
group will change to non-priority scanning. One
of the following messages may be momentarily
displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-
programmed into the radio. A new
Priority 1 group cannot be selected.
FIXD LST
A fixed scan list has been pre-
programmed into the radio. It is not
possible to change the list without
reprogramming the radio.
Note: To quickly view multiple group scan
status, press A then slowly but consistently
rotate the group knob. Each group status will
appear on the display.