Filter
Top Products
TASCAM DR-701D
17
Messages
The following is a list of the pop-up messages.
Refer to this list if one of these pop-up messages
appears on the DR-701D and you want to check the
meaning or determine a proper response.
Message Meaning and response
Battery Empty
The batteries are almost out of
power. Replace the batteries.
Card Error
The SD card could not be recog-
nized properly. Change the card.
Card Full
The SD card has no remaining
space. Erase unnecessary files
or move them to a computer to
make open space.
File Full
The total number of folders
and files exceeds the 5000
limit. Erase unnecessary folders
and files or move them to a
computer.
File Not Found
A file cannot be found or a file
might be damaged. Please
check that file.
File Not Found
Make Sys File
The system file is missing. This
unit requires a system file for
operation. When this message
appears, press the DATA dial to
automatically create a system
file.
File Protected
The file is read only and cannot
be erased.
Format Error
Format CARD
The SD card is not formatted
properly or the card is broken.
This message also appears if
the card was formatted using
a computer connected by USB
or if an unformatted card is
inserted in the unit.
Always use the DR-701D to
format cards to be used with it.
Change the card or press the
DATA dial while this message is
being shown to format the card.
Formatting will erase all the
data on the SD card.
Invalid Card
Change Card
Something might be wrong
with the SD card. Change the
SD card.
Invalid SysFile
Make Sys File
The system file required to
operate this unit is invalid.
When this message appears,
press the DATA dial to automat-
ically create a new system file.
Layer too Deep
Folders can be created down to
two layers. You cannot create
a new folder inside the current
folder.
Message Meaning and response
MBR Error Init
CARD
The SD card is not formatted
properly or the card is broken.
Change the card or press the
DATA dial while this message is
being shown to format the card.
Formatting will erase all the
data on the SD card.
No Card
No SD card is loaded in the unit.
Insert a recordable SD card.
No PB File
There is no file that can be
played back. The file might be
damaged.
Non-Supported
The audio file is not a
supported format. Please see
"Connecting with a Computer"
in the Reference Manual for file
formats that this unit can use.
Switched To
Internal Battery
The power source has switched
from USB bus power to the
batteries in the unit.
Write Timeout
Writing to the SD card timed
out.
Backup files on the card to a
computer, and format the card.
No Rec Channels
Selected
No recording channels have
been selected (all are off).
HDMI CONNECTED
LOCK to HDMI.
HDMI has been connected.
The clock master will switch to
HDMI.
HDMI DISCON-
NECTED
LOCK to INTERNAL
HDMI has been disconnected.
The clock master will switch to
internal.
-HDMI
CONNECTED-
Mismatch Audio
Clock.
Change to **kHz?
HDMI has been connected.
The sampling frequency is
different. Change it?
Fs Mismatch
LOCK to INTERNAL
The sampling frequency has
been changed.
The clock master will switch to
internal.
Fs Match
LOCK to HDMI.
The sampling frequency has
been changed.
The clock master will switch to
HDMI.
If any other error occurs, turn the unit off and restart
it.